What is SPA122?

What is SPA122?

The SPA122 ATA with Router from Cisco effectively combines VoIP services with an internal router for LAN connectivity. The SPA122 ATA comes equipped with two telephone ports allowing for either telephone or fax machine connectivity along with the integrated Ethernet port allowing for high speed Internet access.

Does Cisco SPA112 work with Google Voice?

Answer: It will not work directly with Google Voice, as it does not have the connector for this, however you can use it with any SIP service provider, and use Google Voice with the number that they assign. You can also install the Google Voice connector to an Asterisk PBX, and not need a SIP provider.

How do I reset my Cisco SPA 122?

The Rear-Panel Reset Button Using the end of a paperclip, press it into the red hole marked RESET, located on the bottom-left side of the back panel of the SPA112. Press and hold for at least a full 10 seconds. Cisco documentation is currently stating to hold as much as 20 seconds. 10 seconds is working for me.

How do I reset my Cisco phone adapter?

Factory reset your Cisco SPA112 Hold the reset button down for 30s, or until the power LED light begins to flash again. Release the button. Allow the device to boot up; it may take 2-5 minutes for the reset process to complete. The power LED light will stop flashing once it has initialized.

What is a spa VoIP?

The SPA122 is an intelligent low-density Voice over IP (VoIP) gateway that enables carrier-class residential and business IP Telephony services delivered over broadband or high-speed Internet connections to two standard RJ-11 telephones.

How do I reset my Cisco ATA to factory settings?

Dial the following IVR code using the phone keypad: 73738 (RESET) followed by the # key. The IVR will ask you to confirm by pressing the 1 on the phone keypad. You must hang-up the phone to commence the reboot sequence.

How do I find the IP address of my Cisco spa122?

At the voice prompt menu, enter 110 #. The phone will read back the IP address of the base, which can be entered into a browser to access the configuration. At the voice prompt menu, enter 210 #. The phone will read back the IP address of the base, which can be entered into a browser to access the configuration.

How do I connect to SPA122?

Procedure

1. Using a LAN/Ethernet cable, connect the computer to the yellow Ethernet (LAN) port of the SPA122.
2. Open Internet Explorer browser (IE is required to ensure the adapter’s configuration page displays properly).
3. Log in: admin / (administrator password)
4. Click Voice > Provisioning.
5. Click Submit.

How do I connect my ATA adapter?

How do I provision an analog adapter (ATA)?

1. Plug the Ethernet cord into the Internet port and the analog device into the Phone 1 port. Do not use the Phone 2 or Line ports.
2. Plug in the power adapter.
3. Enter admin for the device username and password. Note: If that password does not work, try voipInfo.
4. Click Submit.

What is Sipuraspa?

Introduction. Sipura SPA-2100 is a multi-port, all-in-one Analog telephone and fax machine adapter. It has two FXS ports(Analog Telephone Adapter), two Ethernet ports(LAN and WAN) and one power-supply jack.