How do you set a floating static route?
To create floating static route(s) you will create identical routes that already exist which go to R2 through the main frame-relay link to traverse the point to point link which have a higher administrative distance so as long as Serial0/0 is up traffic will take that path but if Serial0/0 fails the router will re- …
How do I set a static default route in Cisco?
Perform these steps to configure a default route.
- Enter global configuration mode. device# configure terminal.
- Enter 0.0. 0.0 0.0.
- (Optional) Enable the default network route for static route next-hop resolution.
- (Optional) Configure next-hop recursive lookup to resolve the next-hop gateway.
What is a characteristic of a floating static route?
It is used to provide load balancing between static routes. It is configured with a higher administrative distance than the original dynamic routing protocol has. It is simply a static route with 0.0.
What is a floating static route Cisco?
Floating static routes are static routes that have an administrative distance greater than the administrative distance of another static route or dynamic routes. They are very useful when providing a backup to a primary link, as shown in Figure 2-66.
Where should we use default routing?
Explanation: We must use default routing on stub networks. They have only one exit path out of the network, so there can be no specific path decided for such networks.
What is the difference between default route and default gateway?
The default-route is used on routers, while the default gateway is used on hosts. This router will have two routing rules – one for computers on your internal network, and a default route. The default route will send packets upstream to your ISP.
What is the purpose of a floating static route?
A floating static route is used as a backup route. It has a manually configured administrative distance greater than that of the primary route and therefore would not be in the routing table until the primary route fails. You will test failover to the backup route, and then restore connectivity to the primary route.
On which two routers should a default static route be configured?
Explanation: A stub router or an edge router connected to an ISP has only one other router as a connection. A default static route works in those situations because all traffic will be sent to one destination. The destination router is the gateway of last resort.
