How do you reset the oil light on a 2009?

How do you reset the oil light on a 2009?

Instruction:

1. Turn the ignition to run (one position before starting engine).
2. Press the SELECT/RESET button repeatedly until the engine oil life indicator is displayed.
3. Press and hold the SELECT/RESET button for more than 10 seconds.
4. Press and hold the SELECT/RESET button for more than 5 seconds.
5. DONE!!!

How do you reset the oil light on a Chevy Aveo 5?

How do you reset oil service light indicator Chevrolet Aveo. From years: 2009, 2010.

1. Turn the ignition to run, one position before starting engine.
2. Immediately after step 1 press and release the gas pedal 3 times within 5 seconds.
3. If CHANGE ENGINE OIL light does not go out.

What does the wrench and oil light mean on a Chevy Aveo?

This is a signal that the oil needs changing. If that has been done, then the computer may not have been reset, after it was changed. If that is the case, then turn the switch on, do not crank engine. push the fuel pedal three times, quickly and it should flash, letting you know it has reset.

How do I reset my oil change indicator?

Insert the key into the ignition and turn it to the “on” position without starting the engine. Press the the gas pedal slowly to the floor three successive times within 10 seconds. Turning the ignition off. If the light is still on the next time you start the truck, repeat the process.

Where is the reset button for oil change light?

How to Reset the Oil Light After an Oil Change

1. Turn the car’s systems on, but leave the engine off.
2. Locate the “Reset” button or stick, which is typically located on the dashboard, near the speedometer and fuel gauge.

How do I reset my wrench light?

On certain models, like the 2017 Mazda3, you can reset the Mazda wrench light by pressing and holding the trip button with the ignition switch OFF. After about five seconds, the master light will flash to indicate that the reset process is complete and successfully executed.

How do you reset a 2009 Chevy Aveo?

Turn the ignition on but don’t start the engine. Press the accelerator to the floor 3 times in 5 seconds. The oil light will flash and reset.

How do you reset the oil light on a Chevy?

This is when all the instrument lights on your panel turn on, without the engine running. Wait a few seconds, then press the gas pedal to the floor slowly. Do this three times within about five seconds. Once you do this, look at your oil light.