How do I change the start button on my Seadoo?

Unplug the old start button from the small plastic wiring harness and remove the single retaining screw using a screwdriver. Set the new starter button in place and insert the retaining screw and tighten it.

How do you test a Seadoo Start button?

put positive lead of your voltmeter on the yellow wire, negative lead to the negative on the battery. Press the start button. If you read 12 volts or so everything is good from the button to the solenoid. do the same test with the negative from your voltmeter on the black wire to verify you have a good ground.

How do you start a Seadoo without a key?

if its just the simple push button type you can hold your finger over the button, but if its the DESS type you would need a lanyard key to get it to start.

What does the VTS do on a Seadoo?

This Sea-Doo exclusive accessory lets you exaggerate how high you can raise the nose or how deep you can bury it in the water. The extended range VTS doubles the range of adjustment compared to our current standard VTS.

Why is my Seadoo not starting?

A dead battery is the most common reason for a jet ski not starting. So, if your jet ski won’t start, before doing anything else immediately check the charge on your battery. If you turn the key and nothing happens, then it’s very likely the battery is totally shot and will have to be replaced.

How do you test a Seadoo starter relay?

Put the engine in “drown mode” by holding down the throttle all the way (you can put a rubber band around it to hold it open), then press the start button. The voltage across the solenoid should be no more than 0.2 V. If you show more than 0.2 V going across that connection, then your solenoid is confirmed bad.