What does it mean when my generator says Overcrank?
The overcrank 1100 alarm basically means that the unit is trying to crank, has a good crank signal from the ignition coils (the Evolution controller knows the engine is spinning, just not starting) however is not actually starting and coming up to the normal speed the Evolution is looking for.
How do you reset a Kohler generator?
To reset your Kohler controller, turn the unit OFF by pushing the blue OFF button and wait 30 seconds. Next, push the blue RUN button. The generator will either start or attempt to start three times. If it starts, let it run 5 minutes and then push the blue OFF button again.
What does OC on a generator mean?
the OC fault code is “over crank” which covers a number of problems. If you don´t have a manual for the specific generator call atlantis marine.
What does RPM sensor loss mean on generator?
The error code 1505 is a RPM loss alarm and will trigger a shutdown anytime it occurs and will not self clear. It’s a CRANKING alarm, which means that the alarm occurred during a crank cycle, NOT while the unit was actually running.
What is RPM sensor?
RPM sensor means a mechanism integral to the smokemeter which senses the engine speed in revolutions per minute.
How do I reset my Generac generator after service?
After Performing maintenance, the Maintenance Due light must be cleared. To reset the Maintenance Due light, the generator must be in OFF mode. Set the Generator to OFF and press the OFF button to reset Maintenance Due.
How do you fix a Kohler portable generator that won’t turn on?
Contact an authorized Kohler distributor/dealer. No AC output. Line circuit breaker in the OFF position. Place the circuit breaker in the ON position. overload. Reduce the load on the generator set.
What should I do if my Kohler engine is not working?
If troubles persist after checking the possible causes listed or you are unable to identify the problem, call KOHLER Engines Customer Service at 1-800-544-2444 or contact your local KOHLER dealer. Select Engine Series or Model
What does it mean when your generator says Overcrank?
When you have an improperly maintained generator, you would like to get this error in the future. The overcrank warning means the unit is trying to crank, however is not actually starting and coming up to the typical speed this generator is programmed for.
How do I reset the OnCue controller on my Kohler Generator?
Correct the fault condition and reset the controller. Generator set in the OFF mode. Press the RUN button to start the engine or press AUTO to allow remote starting. switch, ATS,or OnCue. Check the remote switch position. Check OnCue. Engine malfunction. Contact an authorized Kohler distributor/dealer.
