How do you clear the autoshift fault code?
Clearing Fault Codes Turn the key OFF and ON six times within five seconds, ending with the key in the ON position. Note: If the codes have been successfully cleared, the service lamp will come on and stay on for five seconds.
How do you reset Eaton autoshift?
Clearing Fault Codes Manually
- Place shift lever in neutral.
- Set parking brake.
- Turn key on with engine off.
- Turn key off and on 6 times within 5 seconds ending with key on.
- Turn the key off and allow the system to power.
What does F mean on a Eaton transmission?
Active fault code
Flashing “F” in Gear Display Indicates that the transmission has detected an Active fault code. This fault code can be accessed with the ServiceRanger diagnostic software.
How does Eaton AutoShift work?
Using a three pedal system, the Solo self-adjusting clutch is used only for starting and stopping. Once the vehicle is in motion, AutoShift operates like an automatic transmission, with the efficiency of a manual transmission. This transmission is currently only available in Australia, Mexico, and South America.
What is code 88 on Eaton AutoShift?
Fault Code 88 – Inverter CAN Message Fault Detection The following preconditions must be met before the system detects the fault: HCM ignition voltage is greater than 7 volts and less than 16 volts. HCM CAN data link fault is Inactive.
What is the difference between Eaton AutoShift and UltraShift?
Auto shift has a clutch, and then uses the computer and solenoids to do the shifting. Ultrashift doesn’t have a clutch in the cab. Thanks.
What is an AutoShift transmission?
The AutoShift® transmission is an advanced shift-by-wire system consisting of a heavy-duty transmission communicating with an electronic engine utilizing the SAE-J1939 protocol for precise control of the engine and transmission functions. The clutch is used only for starting and stopping.
What is a 10 speed UltraShift transmission?
The UltraShift 10-speed allows drivers to use the transmission in full automatic mode or with manual intervention, depending on conditions or driver preference. A Manual mode holds the current gear and allows driver-selected up-shifts or down-shifts.
Is UltraShift automatic?
The UltraShift PLUS automated transmission is available in six models for linehaul and vocational use. Each transmission offers maximum power capacity, superior acceleration and low-speed maneuverability.
What is AutoShift transmission?
The AutoShift transmission, based on the RT Series manual transmission, is an advanced shift-by-wire system that communicates with the engine utilizing the SAE-J1939 protocol for precise control of the engine and transmission functions.
What are the fault codes for an Eaton Autoshift?
Eaton Autoshift/ Smartshift/ Autoselect transmission Fault Codes list Fault code PID SID Imf Decoding 17 237 4 Winding Relay engine Start 31 62 3,4 Winding of the engine brake relay 33 168 4 Battery voltage Supply 35 231 2,7 Malfunction of engine control system
What does the FMI code on an Eaton Fuller transmission mean?
The FMI may also indicate that an abnormal operating condition has been detected. View or fault code page for instructions on retrieving and clearing fault codes in your Eaton Fuller transmission. Power-up no crank and gear display shows double dash “–”, double stars “**” or blank
What is an Autoshift transmission?
The AutoShift transmission, based on the RT Series manual transmission, is an advanced shift-by-wire system that communicates with the engine utilizing the SAE-J1939 protocol for precise control of the engine and transmission functions. Using a three pedal system, the Solo self-adjusting clutch is used only for starting and stopping.
What is Autoshift 18 used for?
AutoShift 18: Used in many applications where our manual Super 18 is used, including severe duty, heavy haul, construction and high-performance on-highway. Reduces driver skill requirements through ease of operation.
