How do I setup my TP LINK TD W8960N?

How do I setup my TP LINK TD W8960N?

MODEM ROUTER SETUP GUIDETP Link TD-W8960N

1. 1 Attach antennas.
2. 3 If you don’t have dedicated ADSL jack-point, plug ADSL Splitter-Filter into the wall-jack point.
3. 4 If you have dedicated ADSL jack-point, plug phone(DSL) cable from wall jack-point to ADSL port of TL-W8960N.
4. 5 Connect your PC to the router.

How do I use TP LINK TD w8961n as wifi extender?

Step 1 Log into TD-W8961ND’s management page. If you are not sure about how to do this, please click here. Step 2 On the top-side menu, click Interface Setup->Wireless, change the channel to a fixed one, like 4. Step 3 Check the SSID of the main TD-W8961ND, and set the wireless security for it.

What is the default WIFI password for TP Link Router?

admin
The default IP address is 192.168. 0.1(or ), and the default login username and password both are admin (all lower case). 3. Ensure that the IP address of your computer is in the same subnet as the device.

How do I reset my TP LINK TD w8960n?

With the Router powered on, directly press and hold the reset button on the rear panel with a pin for approximately 6 to 10 seconds, Release the reset button and wait for the device to reboot automatically to its factory default settings.

How do I use my tp-link router as a repeater?

How to Configure Repeater Mode on TL-WR702N

1. Power on the WR702N.
2. Click OK to exit.
3. Open a Web Browser -> Type 192.168.0.254 in the address bar -> Press Enter.
4. Enter the default Password: admin.
5. Go to Quick Setup-> Click Next.
6. Select Repeater-> Click Next.
7. Click Survey.

How can I use TP-link WiFi without password?

Simply go to “Advanced—Wireless—Wireless Settings”, click “Sharing Network” and a QR code will generate. Open the camera app on your devices and scan this QR code. Your devices will automatically connect to the you TP-Link router’s WiFi. Note: your camera or app will need to support QR code scanning.

How do I reset my tp link wifi extender?

Locate the pinhole on the side where the reset button is. Insert a pin then press and hold the reset button until all indicator lights turn on momentarily. The range extender should now be reset to factory default settings.