How do I set the default route in Juniper?

How do I set the default route in Juniper?

Solution

1. Connect to the firewall either by console cable or via SSH, go to CLI mode then configuration mode. login: PeteL Password: ************ — JUNOS 12.1X47-D10.4 built 2014-08-14 22:21:50 UTC.
2. Here is the syntax for adding a route, (0.0. 0.0/0 denotes the default route or GOLR).
3. Save the changes.

What is the fxp0 interface in Juniper?

The fxp0 interface is typically an RJ-45 port on the Routing Engine. The me0 interface is typically an RJ-45 port on the Routing Engine. The vme interface is used when the device is part of a Virtual Chassis (VC), and is accessed via the me0 port.

How do I find my IP route in Juniper?

show ip route

1. Syntax. show ip route [ vrf vrfName ] [ destination [ ipMask ] [ detail ] ] [ all ] [ protocol ] [ filter ] To display summary information:
2. Release Information. Command introduced before JunosE Release 7.1.
3. Description. Displays current state of the routing table.
4. Options.
5. Mode. Privileged Exec, User Exec.

How do I set a static route in Juniper?

Configure the interfaces on the R2 (customer) device. Define the IPv4 static default route on the R2 device. Be sure to specify the R1 end of the point-to-point link as the next hop for the static route.

How do I find the default route?

Click Start, click Run, type cmd in the Open box, and then click OK. Type route print, and then press ENTER to view the routing table. Note the interface number of the network interface that you re-added. Type route print to verify that the new default route appears in the routing table.

How do I set up juniper?

Configuring Junos OS for the First Time on a Device with a Single Routing Engine

1. Connect to the device through the console port.
2. Power on the device and wait for it to boot.
3. Log in as the user root .
4. Start the Junos OS command-line interface (CLI):
5. Enter Junos OS configuration mode:
6. Configure the hostname of the device.

How do I check my route on Juniper?

show route-map

1. Syntax. show route-map [ listName ] [ filter ]
2. Release Information. Command introduced before JunosE Release 7.1.
3. Description. Displays all the route maps or the route map you specify. The default is all route maps.
4. Options.
5. Mode. Privileged Exec.

What is show ip route command in Juniper?

This command shows current routes in the routing information base.

How do I set a default static route?

Configuring a default static route

1. Enter global configuration mode. device# configure terminal.
2. Enter 0.0. 0.0 0.0.
3. (Optional) Enable the default network route for static route next-hop resolution.
4. (Optional) Configure next-hop recursive lookup to resolve the next-hop gateway.